Call (405) 752-2474

Go to…

Toyota

We Service and Repair all Toyota cars

  • 2013 Toyota Prius

    Toyota Prius
    Mileage
    142,280
    Service Date
    12/19/2025
    Services Performed
    • We pulled the vehicle into the shop and began testing the HVAC for operation with our computer and we found the vehicle needs a mode door actuator due to its being stuck on the dash vents. To correct the issue we will need to replace the mode actuator. Once the mode actuator was installed and the dash was reassembled the we found the blend actuator was failing when we used the computer to prompt the actuators to reprogram we found it would swing full to one direction and it would stop half way on the return sweep. We cleared the program and attempted to reprogram and we had the same results multiple times. Further testing revels we will need to replace another actuator. Once both actuators were replaced we attempted another reprogram and this time the reprogram was successful and the HVAC is operating as it was designed to.
    • Installed two actuators and after reprogramming the HVAC tested good.
     
    Dale C. gave our service a 5 star review on 12/19/2025

  • 2011 Toyota Sienna

    Toyota Sienna
    Mileage
    98,340
    Service Date
    9/4/2025
    Services Performed
    • Inspected and found coolant lines for rear heat damaged where lines make at 90 degree angle to rear, Recommended replacing heater line set and retest. Called Braun accessibility for cost and eta, eta 1 week and cost is over 1600 with shipping just on the part, we recommended removing and repairing coolant line for much less then the above part cost.
    • We removed both of the damaged heater hoses, and removed the protective wrap off of them. Next we cut the damaged heater pipe under the car and flared it along with cutting some scores into the pipe to ensure that the heater hose would have plenty of grip. After that we cut a new section of hose that was about 2.5 feet long and rewrapped it in the protective wrap, then secured the wrap to the hose with cloth tape and 2 pieces of heat shrink at either end, then spliced that inline with the cut and flared heater pipe. For the other damaged hose we cut about a 2 foot section and repeated the process with the protective wrap and spliced it in. With the modified heater pipe I was unable to reuse the original mounting bracket, so I removed it and made a new mount for the heater hoses/ pipe, along with I took a few pieces of the old hose and cut them down the center and put them around the new hoses where they make contact with each other and the bracket and secured them with zipties to ensure that the hoses could not be rubbed through. We installed all new hose clamps during the process, then pulled 25inHg of vacuum on the cooling system to verify there was no other leaks, then filled the cooling system, and test drove the vehicle and found no other concerns at this time.
     
    Dorthy B. gave our service a 5 star review on 9/5/2025

  • 2007 Toyota Camry

    Toyota Camry
    Mileage
    129,729
    Service Date
    2/13/2025
    Services Performed
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle. 8/32 9mm 8/32 9mm 8/32 9mm 8/32 9mm
     
    Richard T. gave our service a 5 star review on 2/16/2025

  • 2014 Toyota Sienna

    Toyota Sienna
    Mileage
    223,387
    Service Date
    8/15/2024
    Services Performed
    • Inspected and found water pump looks good no leaks or noise with the water pump at this time fuel filter is service in fuel pump and no concerns with fuel pump at this time . Inspected motor mounts no vibration under the hood no concerns with mounts still in good shape .Did inspect and found tire are getting pretty low on tread life fronts are at 4/32 and rears tires still have good tread life at 9/2nds but the inside tread on the tires are cupping . Recommend rear brake pads they are down to 2mm on pads and rotor are solid and not able to be resurfaced recommend replacing rear pads and rotors and front pads have 5mm and are still good at this time.
    • Replaced belt for preventive maintenance
    • Inspected freon and was low removed 1.59 and charged freon back up to 1.72 added tracer dye
    • Serpentine drive belt was replaced and working great
    • Service air conditioner. Check condition of all belts and lines. Evacuate and recharge with reclaimed R-134. Test system performance.
    • Installed new brake pads and replaced rotors. Test drove and vehicle stopping great.
    • install 2 tires and balanced
    • Performed vehicle alignment, adjusted camber, caster, and toe as available. Test drove and vehicle drove straight.
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • INSTALLED BG EPR 109 FLUSH AND RAN VEHICLE. CHANGED OIL AND FILTER AND INSTALLED BG MOA ADVANCED FORMULA.
     
    Lora S. gave our service a 5 star review on 8/15/2024

  • 2015 Toyota Venza

    Toyota Venza
    Mileage
    127,345
    Service Date
    7/10/2024
    Services Performed
    • Sublet to OKC headlight repair. Sanded and wrapped headlights. 3 year warranty.
     
    Steven H. gave our service a 5 star review on 7/11/2024

  • 2008 Toyota Tundra

    Toyota Tundra
    Mileage
    156,131
    Service Date
    4/2/2024
    Services Performed
    • Test and found the transfer case actuator binding up. Also found rear left wheel bearing and speed sensor not working and differential lock actuator not engaging. Recommend RR left wheel bearing speed sensor and replacing differential actuator.
    • Install diffrential lock actuator test and working as design
    • WHEEL BEARING – Remove & Replace – Rear,One Side – [Includes: Bleed Brakes.] – [Includes: Replace Inner and/or Outer Bearings, Cups, Seals and repack (where applicable).]
    • FLUSHED DIFFERENTIAL WITH NEW FLUID AND ADDED CORRECT CONDITIONERS.
    • Advise customer called and states cruise control not working, check please.
     
    IRVEN M. gave our service a 5 star review on 4/4/2024

  • 2008 Toyota Sequoia

    Toyota Sequoia
    Mileage
    228,000
    Service Date
    2/13/2024
    Services Performed
    • scanned for codes and found p0304 miss fire on cylinder #4 removed air box and tested for spark and found that spark is good tested for injector pulse and found injector is pulsing and injector flow is good checked for compression and found no compression and that cylinder is loaded with oil. the only repair is to replace engine.
     
    Zachary T. gave our service a 5 star review on 2/13/2024

  • 2007 Toyota Sequoia

    Toyota Sequoia
    Mileage
    185,829
    Service Date
    12/4/2023
    Services Performed
    • Aib bags not working recommend replacing both air bags. AAlso found nail in left
    • AIR SUSPENSION SPRINGS – Remove & Replace – Both
     
    Robert P. gave our service a 5 star review on 12/4/2023

  • 2011 Toyota Tundra

    Toyota Tundra
    Mileage
    64,142
    Service Date
    6/6/2023
    Services Performed
    • Diagnosed dtc p2447 and found injection air pump has correct power and ground but it is not build pressure, no leaks found. Recommended new pump and retest.
    • Replaced air injection pump and cleared dtc. Checked and air pump building correct pressure. No leaks found and emission test passing.
     
    EDDIE T. gave our service a 5 star review on 6/6/2023

  • 2011 Toyota Camry

    Toyota Camry
    Mileage
    116,304
    Service Date
    2/20/2023
    Services Performed
    • Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
    • 4 WHEELS ROTATION COMPLETE
    • CLEANED BATTERY TERMINALS AND ADDED BG BATTERY TERMINAL PAD KIT.
     
    TJ L. gave our service a 5 star review on 2/20/2023